Safety shoes SBP

2 products

Showing 1 - 2 of 2 products

SBP safety shoes meet the SB basic category of EN ISO 20345, supplemented by a puncture-resistant midsole. This makes them suitable for workplaces where nails, screws or sharp debris may be on the floor, without the additional requirements of the S classes.

The selection is small: two leather ankle boots from the Portwest Steelite range, a nubuck and a smooth leather model. Both have an outsole that is resistant to contact heat (HRO). Below you will read when SBP is sufficient and when another class is better suited.

Showing 1 - 2 of 2 products

FW35 - Steel Nubuck lederen enkellaars SBP HRO - Portwest - Honey

Steel Nubuck lederen enkellaars SBP HRO - Portwest FW35 Portwest

Portwest Steel Nubuck leather ankle boot SBP HRO - Portwest FW35

€59,63

FW16 - Steel Action lederen enkellaars SBP HRO - Portwest - Zwart

Steel Action lederen enkellaars SBP HRO - Portwest FW16 Portwest

Portwest Steel Action Leather Ankle Boot SBP HRO - Portwest FW16

€38,96

The P makes the difference

Penetration injuries are unpleasant and treacherous: you don't see a nail in a plank on the floor, and a regular sole won't stop it. The penetration-resistant midsole of an SBP shoe does, using a steel plate or a textile insert. Under the new classification, that textile variant is called SBPS or SBPL, depending on the nail thickness it was tested with.

SBP or S1P?

The difference lies in what else is required. S1P has, in addition to penetration protection, an anti-static construction, a closed heel area and an energy-absorbing heel. In most industrial environments that's the better choice; SBP is there for situations where those properties aren't needed.

Veelgestelde vragen

What does the P add to SBP?

The P stands for a penetration-resistant midsole: a steel plate or textile insert that stops a nail or shard from going through the sole into your foot. SBP is therefore SB plus that protection, without the anti-static and energy-absorbing requirements of S1.

Steel or textile as the penetration-resistant layer?

A steel plate protects across the full width and is tested with a 4.5 mm nail. A textile insert is lighter, more flexible and doesn't conduct cold, and in the S variants is tested with a thinner 3.0 mm nail, which actually protects better against thin sharp objects.

Is een SBP-werkschoen antistatisch?

Nee, antistatische eigenschappen zijn geen eis voor SB of SBP. Die horen pas bij de S-klassen, vanaf S1. Werk je met elektronica, brandbare stoffen of in een ATEX-zone, kies dan een S1P- of S3-schoen, of een ESD-werkschoen als je in een ESD-beschermde zone werkt.

Voor wie is een SBP-werkschoen geschikt?

Een SBP-schoen past bij werk waar je voeten beschermd moeten zijn tegen vallende voorwerpen en scherpe objecten op de grond, maar waar antistatische eigenschappen of een energieabsorberende hiel niet nodig zijn. Denk aan opruimwerk, sloop of houtbewerking in een droge omgeving.

Staat jouw vraag er niet bij? Stel hem aan onze specialisten.

The P makes the difference

SBP or S1P?

Veelgestelde vragen

Welcome